Every fall it's the same story. The first real cold snap hits, and a shop that's cut clean all summer starts going through electrodes, fighting hard starts and grinding dross that wasn't there in September. Nothing on the machine changed. The weather did.
Winter is hard on a plasma cutter in a few specific ways. Most of them come back to the air.
Cold lines make wet air
Your compressor heats the air it squeezes, and hot air holds moisture as vapour. As that air cools on its way to the machine, the water drops out as liquid. That happens all year. Wet Air Is Killing Your Plasma Consumables covers the whole picture.
Winter changes where it happens. When air lines run along a cold outside wall, through an unheated bay or out to a compressor shed, the air keeps cooling after it's passed your dryer and filters. The water can come out of the air downstream of everything that was supposed to catch it, and ride straight into the torch.
What to do:
- Put a filter right at the machine, as the last stage before the torch.
- Where you can, keep air lines off cold outside walls and out of unheated spaces.
- Check the filter bowl at the machine more often once the cold arrives. If it's catching water now and wasn't in the summer, that's your answer.
Drains freeze
A receiver tank drain or filter drain in an unheated space can freeze shut. An automatic drain that's frozen does nothing, and the tank fills with water while everyone assumes it's handling itself.
- If the compressor lives somewhere cold, open the tank drain by hand and check it actually runs.
- Make sure drain lines can't hold standing water that freezes overnight.
A cold torch in a warm shop sweats
Bring a torch or a box of consumables in from a cold truck or an unheated bay, and the warm shop air condenses on it like a cold can of pop. That moisture gets into the stack.
- Let a cold torch and cold consumables come up to shop temperature before you cut.
- Store spare consumables inside, in a dry spot, not in the truck.
Cold leads crack
Torch leads stiffen in the cold. A lead that flexes fine in summer can crack its jacket when it's bent hard or stepped on in a cold bay. A cracked lead lets moisture and dirt in.
- Don't kink or force a cold lead. Uncoil it and let it warm up.
- Run your hand along it every so often through the winter. Cracks start where it bends most, usually near the handle and at the machine end.
Our air plasma maintenance post covers the full lead and torch check.
Liquid-cooled torches can freeze solid
If you run a liquid-cooled CNC system and the shop drops below zero overnight, check your coolant's freeze protection before the first cold night, not after. Coolant that freezes in a torch or hose can crack it. More on liquid-cooled torches here.
The winter checklist
| Check | What you're looking for |
|---|---|
| Filter bowl at the machine | water that wasn't there in the summer |
| Tank and filter drains | frozen shut, or not actually draining |
| Air line routing | lines running through cold walls or unheated spaces |
| Torch and consumables | brought in cold and used before they warm up |
| Torch leads | cracks in the jacket, especially at the bends |
| Coolant (liquid-cooled) | freeze protection for your coldest night |
None of these are expensive to fix. Ignored, they all show up the same way: consumables that die early and get blamed for it.
Need consumables? Our guided finder walks you from your machine to the complete stack, in the order the parts go into the torch, with the OEM number each one crosses to. Find your consumables →
TorchandTip.com sells Thermacut® aftermarket plasma consumables and Binzel® MIG welding consumables across Canada. Thermacut® is an independent manufacturer. TorchandTip.com is not affiliated with, authorized by, or endorsed by Hypertherm®, ESAB®, Lincoln Electric®, Kjellberg®, or any other original equipment manufacturer. All OEM names, model numbers, and part numbers are used for identification and reference purposes only.
0 comments